page 69 of 73
REQUIREMENTS AND LIMITATIONS
REQUIREMENTS AND LIMITATIONS
The router must be placed on hard and perfectly level surface.
The PC and the electronic controller must be connected to the same electric phase. Both should
be plugged into the same surge protector. The power line must be properly grounded.
Both MegaCut and MegaCut 3D can be installed on the following Windows OS: 2000, XP, Vista
or 7.
In order to avoid interference in the constant PC-controller connection, please turn off the
following in your PC:
– all power saving modes,
– screen saver
Max. drawing/model size
– 2D - the only limitation is the working are of the machine
– 3D - limited by the PC hardware (memory plus CPU). If the PC is sufficiently strong and
fast, 3D models of up to 50x50 cm should work fine (sometimes up to 1x1 meter). It is
highly recommended to equip the PC in as much RAM as possible (at least 4GB) when
working with 3D models.
The supplied software is only used to control the machine, you will still need your own graphics
software to prepare the shapes/drawings/models.
You cannot start but MegaCut and MegaCut 3D at the same time, only one should be opened at
any given time.
www.megaplot.com phone: +48 693 707 575 office@megaplot.com
To Next Page
Loading...
