page 53 of 73
Tools library
Tools library
The tools library is the collection of tools used by the machine for given operations. Note the
tools are sorted by their diameter, not name.
There is no limit on the number of tools you can save, giving each of them a name you caneasily
recognize.
You can define three different types of tools: flat, ball and conical. Flat tools are mostly used for
the roughing operations as well as for surfacing operations. Ball tools are most often used for the
finishing operations and the conical tools are mostly used for very fine details only.
On the right side of the tool library there are buttons which allow to add, edit and delete tools
from the library. When adding a new tool, make sure you specify all of its parameters. Note the
number and types of parameters that need to be specified depend on the type of the tool.
www.megaplot.com phone: +48 693 707 575 office@megaplot.com
To Next Page
Loading...
