page 64 of 73
This window can display in the alternative, touch-friendly mode as described earlier (Control
Window - enlarged).
Homing process
Homing (Manual Control – Home button) is used to bring the machine back to its original home
position by calibrating it in relation to the proximity sensors. It is recommended to perform the
homing process when the machine was blocked while moving or the tool got stuck inside of
material because of wrong cutting parameters. If the machine gets stuck in the material or by hitting
an object on its table, you will hear the sound of the motors trying to overcome the obstacle. In this
case, home the machine to bring it back to its original home position.
www.megaplot.com phone: +48 693 707 575 office@megaplot.com
To Next Page
Loading...
