SDM-9XXX SeriesHardware Installation Guide
1-2 Memotec Inc.
1.1 Product Overview
1.1.1 SDM-9120
The NetPerformer SDM-9120 is an entry-level standalone chassis designed for network
convergence at the branch office level. It is a high speed, low cost, flexible and compact
unit that supports 8 analog or 60 digital telephony channels in a multitude of application
scenarios.
The SDM-9120 base unit has a 1U chassis with:
• One universal serial port equipped with HD-26 female connector (up to 8Mbps)
• Two 10/100Base-T Ethernet ports (RJ45 connectors)
• One console port
• One internal connector for DSP
• Up to 8 FXS/FXO or E&M, or 60 T1/E1 CAS/PRI (lease lines) digital channels
per unit.
• Two expansion slots.
• All UAC base units come equipped with universal AC power supply and a choice
of 120 VAC North American or 240 VAC European power cord (must be speci-
fied at time of ordering).
• A DB9F-DB9F console cable and 19-inch rackmount kit are also included in the
product package.
• A custom cable (HD-26 male connector) is required for the serial port, available
from Memotec Inc. or your NetPerformer distributor.
The basic software set provides support of PowerCell Voice and Data (including legacy
user data) and IP routing over Ethernet, serial or digital ports using PPP or Frame Relay
RFC-1490. Optional software licenses can be procured for support of:
• SkyPerformer satellite access
• TCP Acceleration
• SIP VoIP
• IP header compression
• Link Delay Compensation
• IPv6.
1.1.2 SDM-9220
The NetPerformer SDM-9220 is an entry-level standalone chassis designed for network
convergence at the branch office level. It is a high speed, low cost, flexible and powerful
unit that supports 8 analog or BRI/ST digital voice connections in a multitude of
application scenarios.
To Next Page
Loading...
Need help?
General
