SDM-9XXX Series Hardware Installation Guide
3-32 Memotec Inc.
3.12.2 Activating the Console Connection
To activate the console connection:
1. Ensure that the SDM-9120/9220/9230 unit has successfully powered up with no
system status errors (see “System Status on Power-up” on page 3-29).
2. Power the console terminal on or start your console terminal emulation program.
Take note of: “Important Console and Modem Settings for Startup” on page 3-31
3. When you see the prompt
Type <ENTER> to connect, press the <Enter> key on the
console terminal keyboard several times, until the SDM-9120/9220/9230 responds
with a prompt for the user login.
4. Enter the administrator login:
ADMIN.
This is the default login. Additional user logins can be defined. Refer to the
NetPerformer Reference Guides for details.
5. Enter the password for this login.
When the password is entered correctly, the SDM-9120/9220/9230 sends the
product banner to the console screen, as in this example:
LOGIN:ADMIN
PASSWORD:*****
ACCEPTED
SDM-9230 vx.x.x Memotec Technologies, Inc. (c) 2007
Signaling Engine x.x.x
DSP code version: x.x.x
Console connected on port CSL
B327091>
NOTE: The default password for the administrator login is SETUP. Consult the Net-
Performer Reference Guides for instructions on how to change or remove the
user password, if desired.
6. Enter the Display Alarms (
DA) command at the NetPerformer console command line
to verify that your unit is problem free. In particular, look for any alarm messages that
indicate
Call Technical Support.
To Next Page
Loading...
Need help?
General
