SDM-9XXX SeriesHardware Installation Guide
1-8 Memotec Inc.
1.3 Changes to Console Operations
The following change to console operations was made in NetPerformer firmware version
V9.2.0, and still applies to firmware version V10.1.X and higher. If you are familiar with
earlier versions of the NetPerformer firmware, this change should be taken into
consideration before you configure or manage the product.
• The way you access the NetPerformer console has changed to allow for multiple
user profiles:
CAUTION:: The default LOGIN is now ADMIN instead of ACT.
NOTE: The default PASSWORD for this login remains SETUP.
For full instructions on setting up user profiles, refer to the Quick Configuration module of
the NetPerformer Reference Guides.
To Next Page
Loading...
Need help?
General
