Mercury 200 VERADO User Manual

OPERATION
94
!
CAUTION
Never start or operate your outboard (even momentarily) without
water circulating through all the cooling water intake holes in the
gearcase to prevent damage to the water pump (running dry) or
overheating of the engine.
1. Make sure the cooling water intake is submerged.
ob01310
2. Check the engine oil level.
ob00667
3. Open fuel tank vent on manual venting type tanks.
19748
NOTE: The engine will not start unless the lanyard is set to the
"RUN" position.

Mercury 200 VERADO Specifications

General

Engine Type	4-Stroke
Gear Ratio	1.85:1
Full Throttle RPM Range	5800-6400 RPM
Fuel System	Electronic Fuel Injection (EFI)
Exhaust	Through Prop
Horsepower	200 HP
Fuel Induction System	Electronic Fuel Injection (EFI)
Shaft Length	20", 25"
Starting	Electric
Fuel Type	87 Octane
Cylinder Configuration	Inline-6
Cooling System	Water-cooled with thermostat