EasyManuals Logo

Mercury 200 VERADO User Manual

Mercury 200 VERADO
145 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #110 background imageLoading...
Page #110 background image
MAINTENANCE
102
Tube Ref No. Description Where Used Part No.
81
Anti-Seize
Compound
Spark plug threads 92-881091K1
Check wiring and connectors.
Check tightness of bolts, nuts, and other fasteners.
Check cowl seals to make sure seals are intact and not
damaged.
Check internal cowl sound reduction foam (if equipped) to
make sure foam is intact and not damaged.
Check that the intake silencer (if equipped) is in place.
Check that the idle relief muffler (if equipped) is in place.
Check for loose hose clamps and rubber boots (if equipped)
on the air intake assembly.
EVERY 300 HOURS OF USE OR THREE YEARS
IMPORTANT: Engine oil must be drained before removing
gearcase to avoid oil spillage. Perform scheduled water pump
replacement in combination with an engine oil change.
Replace water pump impeller (more often if overheating
occurs or reduced water pressure is noted).
1.
Check power trim fluid. See Checking Power Trim Fluid.
Replace high pressure in-line fuel filter.
1.
Replace spark plugs at first 300 hours or three years. After
that, inspect spark plugs every 300 hours or three years.
Replace spark plugs as needed. See Spark Plug Inspection
and Replacement.
Replace accessory drive belt. See Accessory Drive Belt
Inspection.
1.
BEFORE PERIODS OF STORAGE
Refer to Storage procedure. See Storage section.
Flushing The Cooling System
Flush the internal water passages of the outboard with fresh water
after each use in salt, polluted, or muddy water. This will help
prevent a buildup of deposits from clogging the internal water
passages.

Table of Contents

Other manuals for Mercury 200 VERADO

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 200 VERADO and is the answer not in the manual?

Mercury 200 VERADO Specifications

General IconGeneral
Engine Type4-Stroke
Gear Ratio1.85:1
Full Throttle RPM Range5800-6400 RPM
Fuel SystemElectronic Fuel Injection (EFI)
ExhaustThrough Prop
Horsepower200 HP
Fuel Induction SystemElectronic Fuel Injection (EFI)
Shaft Length20", 25"
StartingElectric
Fuel Type87 Octane
Cylinder ConfigurationInline-6
Cooling SystemWater-cooled with thermostat

Related product manuals