Mercury 200 VERADO User Manual

MAINTENANCE
122
Checking Power Steering Fluid
Remove power steering cover and fill cap to check fluid level. The
fluid level should be slightly below the bottom of the fill hole. Use
SAE 0W-30 synthetic power steering fluid, if needed.
ob01527
a
b
c
a - Power steering cover
b - Fill cap
c - Fill/full level
Tube Ref No. Description Where Used Part No.
138
Synthetic Power
Steering Fluid SAE
0W-30
Power steering system 92-858002K01
Changing Engine Oil
ENGINE OIL CAPACITY
Engine oil capacity is approximately 7.0 liters (7.4 quarts).
PUMP METHOD
IMPORTANT: Tilt outboard out/up past vertical for approximately
one minute to allow trapped oil to drain back to the oil sump.
IMPORTANT: To reduce or prevent oil spillage when removing the
oil filter, make sure that the outboard is upright (not tilted) and the
engine is cold or has not run for at least one hour.

Mercury 200 VERADO Specifications

General

Engine Type	4-Stroke
Gear Ratio	1.85:1
Full Throttle RPM Range	5800-6400 RPM
Fuel System	Electronic Fuel Injection (EFI)
Exhaust	Through Prop
Horsepower	200 HP
Fuel Induction System	Electronic Fuel Injection (EFI)
Shaft Length	20", 25"
Starting	Electric
Fuel Type	87 Octane
Cylinder Configuration	Inline-6
Cooling System	Water-cooled with thermostat