Mercury 200 VERADO User Manual

MAINTENANCE
123
IMPORTANT: The pump method is preferred to remove engine oil
from XXL models. If the drain method is used, an oil drain funnel
must be used to divert oil from the lower splash plate and into the
container.
1. Tilt outboard out/up past vertical for approximately one minute
to allow trapped oil to drain back to the oil sump.
2. Place the outboard in a vertical position.
3. Remove dipstick and slide adaptor tube of crankcase oil pump
through oil dipstick hole, to bottom of engine oil sump.
4. Pump out the engine oil into an appropriate container.
Crankcase Oil Pump 91-90265A 5
11591
Aids in the removal of engine oil
without draining the crankcase.
DRAIN METHOD
1. Tilt outboard out/up past vertical for approximately one minute
to allow trapped oil to drain back to the oil sump.
2. Place the outboard in a vertical position.
3. Place appropriate container under engine oil sump plug. Drain
plug/seal washer is located beneath the splash plate (port side
of outboard).

Mercury 200 VERADO Specifications

General

Engine Type	4-Stroke
Gear Ratio	1.85:1
Full Throttle RPM Range	5800-6400 RPM
Fuel System	Electronic Fuel Injection (EFI)
Exhaust	Through Prop
Horsepower	200 HP
Fuel Induction System	Electronic Fuel Injection (EFI)
Shaft Length	20", 25"
Starting	Electric
Fuel Type	87 Octane
Cylinder Configuration	Inline-6
Cooling System	Water-cooled with thermostat