Mercury 200 VERADO User Manual

MAINTENANCE
124
4. Loosen the drain plug/seal washer. Install the oil drain funnel
over the drain plug/seal washer and slide the tool onto the
splash plate.
ob01264
a
b
a - Drain plug/seal
washer
b - Oil drain funnel
Oil Drain Funnel 91-892866A01
4993
Diverts draining engine oil from
contacting the anti-splash and
anti-cavitation plates.
5. Remove drain plug/seal washer and drain engine oil into
container.
6. Reinstall drain plug/seal washer.
CHANGING OIL FILTER
IMPORTANT: To reduce or prevent oil spillage when removing the
oil filter ensure that the outboard is upright (not tilted) and the
engine is cold or has not run for at least one hour.
1. Remove the top cowl.
2. Place a rag or towel below the oil filter to absorb any spilled
oil.

Mercury 200 VERADO Specifications

General

Engine Type	4-Stroke
Gear Ratio	1.85:1
Full Throttle RPM Range	5800-6400 RPM
Fuel System	Electronic Fuel Injection (EFI)
Exhaust	Through Prop
Horsepower	200 HP
Fuel Induction System	Electronic Fuel Injection (EFI)
Shaft Length	20", 25"
Starting	Electric
Fuel Type	87 Octane
Cylinder Configuration	Inline-6
Cooling System	Water-cooled with thermostat