Mercury 200 VERADO User Manual

INSTALLATION
29
Installing Outboard
!
WARNING
Before operation, the outboard must be correctly installed with
the required mounting hardware as shown. Failure to correctly
fasten outboard could result in outboard ejecting off boat transom
causing serious injury, death, or property damage.
IMPORTANT: For optimum boat performance and detailed engine
installation instructions, refer to the outboard installation manual,
supplied with the outboard.
We strongly recommend that your dealer install your outboard and
related accessories to ensure proper installation and good
performance. If you install the outboard yourself, follow instructions
in the Outboard Installation Manual which is provided with the
outboard.
The outboard must be secured to the boat transom with the four
12.7 mm (1/2 in.) diameter mounting bolts, locknuts and washers
provided. Install two bolts through the upper set of mounting holes
and two bolts through the lower set of mounting slots.
ob01306

Mercury 200 VERADO Specifications

General

Engine Type	4-Stroke
Gear Ratio	1.85:1
Full Throttle RPM Range	5800-6400 RPM
Fuel System	Electronic Fuel Injection (EFI)
Exhaust	Through Prop
Horsepower	200 HP
Fuel Induction System	Electronic Fuel Injection (EFI)
Shaft Length	20", 25"
Starting	Electric
Fuel Type	87 Octane
Cylinder Configuration	Inline-6
Cooling System	Water-cooled with thermostat