STORAGE
130
Tube Ref No. Description Where Used Part No.
124
Fuel System
Treatment &
Stabilizer
Fuel tank 802875A1
Protecting External Outboard Components
• Touch up any paint nicks. See your dealer for touch-up paint.
• Spray Quicksilver or Mercury Precision Lubricants Corrosion
Guard on external metal surfaces (except corrosion control
anodes).
Tube Ref No. Description Where Used Part No.
120
Corrosion Guard
External metal
surfaces
92-802878-5
5
Protecting Internal Engine Components
IMPORTANT: Refer to Maintenance - Spark Plug Inspection and
Replacement for correct procedure for removing spark plugs.
• Remove pencil coils and spark plugs.
• Spray approximately 30 ml (1 fl. oz.) of Storage Seal Rust
Inhibitor into each spark plug hole.
Tube Ref No. Description Where Used Part No.
119
Storage Seal Rust
Inhibitor
Spark plug holes
92-802878-5
6
• Actuate key/push button start switch to crank the engine
through one start cycle, which will distribute the storage seal
throughout the cylinders.
• Reinstall spark plugs and pencil coils.
Gearcase
• Drain and refill the gearcase lubricant (refer to Maintenance -
Gearcase Lubrication).
Positioning Outboard For Storage
Store outboard in an upright (vertical) position to allow water to
drain out of outboard.
To Next Page
Loading...
Need help?
General
