Mercury 200 VERADO User Manual

OPERATION
98
Stopping The Engine
IMPORTANT: Turning key to the "START" position while the
engine is running will result in engine shut down, while leaving the
DTS system active. This will allow the use of the power trim/tilt from
the remote control handle.
Reduce engine speed and shift outboard to neutral position. Turn
ignition key to "OFF" position.
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
3482

Mercury 200 VERADO Specifications

General

Engine Type	4-Stroke
Gear Ratio	1.85:1
Full Throttle RPM Range	5800-6400 RPM
Fuel System	Electronic Fuel Injection (EFI)
Exhaust	Through Prop
Horsepower	200 HP
Fuel Induction System	Electronic Fuel Injection (EFI)
Shaft Length	20", 25"
Starting	Electric
Fuel Type	87 Octane
Cylinder Configuration	Inline-6
Cooling System	Water-cooled with thermostat