EasyManuals Logo

Mercury 200 VERADO User Manual

Mercury 200 VERADO
145 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #111 background imageLoading...
Page #111 background image
MAINTENANCE
103
NOTE: The outboard can be tilted or in the vertical operating
position during flushing.
1. With the engine turned off, place the outboard in either the
operating position (vertical) or in a tilted position.
2. Disconnect the flush connector from fitting on the bottom cowl.
ob01236
3. Thread a water hose into the flush fitting.
ob01237
4. Turn on the water tap (1/2 maximum) and let the water flush
through the cooling system for about 15 minutes.
5. When flushing is complete, turn off water and disconnect the
water hose.
6. Reinstall the flushing connector to the fitting on the bottom
cowl. Tighten the connector securely.
Cowl Removal and Installation
COWL REMOVAL
IMPORTANT: Most maintenance points are accessible by
removing the top cowl only.

Table of Contents

Other manuals for Mercury 200 VERADO

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 200 VERADO and is the answer not in the manual?

Mercury 200 VERADO Specifications

General IconGeneral
Engine Type4-Stroke
Gear Ratio1.85:1
Full Throttle RPM Range5800-6400 RPM
Fuel SystemElectronic Fuel Injection (EFI)
ExhaustThrough Prop
Horsepower200 HP
Fuel Induction SystemElectronic Fuel Injection (EFI)
Shaft Length20", 25"
StartingElectric
Fuel Type87 Octane
Cylinder ConfigurationInline-6
Cooling SystemWater-cooled with thermostat

Related product manuals