Mercury 200 VERADO User Manual

FEATURES AND CONTROLS
47
NOTE: The active light on the remote control will be illuminated at
the helm that is in control of the engine.
The helm transfer function allows the boat operator to select which
helm is in control of engine operation. Pressing the throttle only/
station select button two times allows engine control to be
transferred to a new helm. When a helm transfer is initiated, the
control will automatically start adjusting engine RPM and gear
position to match the control handle setting at the new helm. Adjust
the control handles to the desired throttle and gear position.
NOTE: There is a 10 second time frame to complete a helm
transfer. If the helm transfer is not completed, the action will be
cancelled and a double beep will sound. Pressing the throttle only/
station select button again will re-initiate a helm transfer.
1. Place active remote control lever to idle position.
2. Proceed to the inactive helm and position remote control lever
to the idle position.
3. Press throttle only/station select button two times. The
"ACTIVE" light will illuminate to indicate the remote control is
in control of the engine.
ACTIVE
STATION SELECT
ACTIVE
SYNC
STAT ION SELECT
THROTTLE
ONLY
THROTTLE
ONLY
22753
a
b
a
b
a - Active light b - Throttle only/station
select button
4. The "ACTIVE" light will switch off at the original helm.

Mercury 200 VERADO Specifications

General

Engine Type	4-Stroke
Gear Ratio	1.85:1
Full Throttle RPM Range	5800-6400 RPM
Fuel System	Electronic Fuel Injection (EFI)
Exhaust	Through Prop
Horsepower	200 HP
Fuel Induction System	Electronic Fuel Injection (EFI)
Shaft Length	20", 25"
Starting	Electric
Fuel Type	87 Octane
Cylinder Configuration	Inline-6
Cooling System	Water-cooled with thermostat