- 29 -
AP Isolation - Select this checkbox to enable the AP Isolation feature that allows you to
confine and restrict all wireless devices on your network from interacting with each other, but
still able to access the Internet. AP isolation is disabled by default.
5.3.2 WDS Bridging
Go to 5GHz Wireless
WDS Bridging, and follow the steps below to configure WDS bridging
settings.
1. Click Next to start the setup.
2. Select a network from the table and enter the password, or you can click Add router
manually and enter the network name and password. Then click Next.
3. Enter the wireless parameters of your router. It is recommended to set the same SSID and
Password as the root router. Then click Next.
To Next Page
Loading...
