20
4) Threading the (Orange)Overedge Left Needle
(A on needle clamp)
Thread the eye of the right needle 9.
Note: Use of tweezers in the accessory case will
make needle eye threading easy.
The position of the thread must be behind the thread
guide.
Draw about 10cm(4 inches) of thread through
needle eye towards the rear of machine.
Place the thread to the back, under the presser
foot.
Pass thread from back to the front through the
thread guide 1.
Thread the left needle as indicated 1~9.
Raise Presser foot to release Tension discs.
Continue to thread points 4~8.
Note: Slip thread into the rear slot on the thread
guide 5 and bottom slot of take-up lever cover 6.
Then slip thread into the right slot on the thread
guide 7, and into the right slot on the thread
guide 8.
4
1
7
5
6
7
3
2
1
8
7
6
5
4
(4")
10cm
Before threading eye of needle, slip thread behind
thread guide located on the bottom of the needle
clamp.
9
8
9
9
8
To Next Page
Loading...
Need help?
General
