21
While holding thread with fingers, pass it between
the tension discs and pull thread down to make
certain it is properly located in between the
tension discs 3.
Thread the eye of the left needle 9.
Note: Use of tweezers in the accessory case will
make needle eye threading easy.
The position of the thread must be behind the
the thread guide.
Draw about 10cm (4 inches) of thread through
needle eye to hang free.
Place the thread to the back, under the presser
foot.
Continue to thread points 4~8.
Note: Slip thread into the front slot of the thread
guide 5 and into the lower slot of take-up
lever cover 6.
Then continue by slipping thread into the
Left slot of the thread guides 7 and 8.
Before threading eye of needle, slip thread behind
thread guide located on the bottom of the needle
clamp.
4
3
2
7
3
2
8
7
5
4
6
3
2
(4")
10cm
Thread the top cover
threadguide by pulling
the thread towards the
left until it slips under
guide. Then pull thread
along the right side of
button as illustrated.
9
8
9
To Next Page
Loading...
Need help?
General
