Metaflex SDA-04DCB2 - Fault Codes and Possible Solutions

Installers manual 10.03.02-R03 (201058) EN SDA-04 (SW 5.xx) - SDA-04DCB2 (SW 22.00) Page 35 of 55
10 Fault codes and possible solutions
General
External operation/control
Remove signal (Input 12)
Meaning
Clear message
Full-open Inside
Remove signal (Input 15)
Half-open Inside
Remove signal (Input 16)
General
Special operation
Meaning
Meaning
Initialisation in process
Waiting until configuration is complete
Lock or sluice input 1 is active
Cancel contact or sluice (Input 1)
One-way active
Key or rotary switch (Input 2)
Any active electrical interlocks are lifted
up
Restore "N.C." (Input 4)
Emergency stop operated
Emergency stop is operated (Input 6 (or 1))
Door assumes fire position
Restore "N.C." (Input 5)
Lock problem ->
no feedback
Open circuit or lock not locking (Input 23)
General
Obstruction messages
Meaning
Clear message
Obstruction in indentation
Remove obstruction
Obstruction during opening
Remove obstruction, door is too heavy,
check mechanical adjustments
Obstruction during closing
Remove obstruction, door is too heavy, check
mechanical adjustments
Indentation boost =
retighten in indentation when closing
Call the service department
DMS obstruction check
Remove obstruction or
door has too much resistance