Transport, Packaging and Storage
PRM 10 E | Version 1.05 | EN 11
4 Transport, Packaging and Storage
4.1 Delivery and Transport
Delivery Check the machine for visible transport damage after delivery. If the machine
is damaged, it must be reported immediately to the transport company or the
dealer.
Transport Improper transport is accident-prone and can cause damage or malfunctions
for which we do not grant any liability or guarantee.
Transport the scope of delivery secured against shifting or tilting with a suffi-
ciently dimensioned industrial truck to the installation site.
General risks during internal transport
Devices may only be transported by authorized and qualified persons. Act re-
sponsibly during transport and always consider the consequences. Refrain
from daring and risky actions.
Gradients and descents (e.g. driveways, ramps and the like) are particularly
dangerous. If such passages are unavoidable, special caution is required.
Before starting the transport check the transport route for possible danger
points, unevenness and disturban-ces as well as for sufficient strength and
load capacity.
WARNING!
Severe or fatal injuries may occur if parts of the machine tumble or
fall down from the
forklift truck, pallet truck or from the transport vehicle.
Follow the instructions and information on the transport box.
Note the total weight of the machine. The weight of the machine is indica-
ted in the "Technical data" of the machine. When the machine is unpacked,
the weight of the machine can also be read on the rating plate.
Only use transport devices and load suspension gear that can hold the
total weight of the machine.
WARNING!
The use of unstable lifting and load suspension equipment that might
break under load can cause severe injuries or even death. Check that the
lifting and load suspension gear has sufficient load-bearing capacity and
that it is in perfect condition.
Observe the accident prevention regulations issued by your Employers
Liability Insurance Association or other competent supervisory authority,
responsible for your company.
Fasten the loads properly.
WARNING: DANGER OF TIPPING
The device may be lifted unsecured by a maximum of 2cm.
Employees must be outside the danger zone, the reach of loads.
Warn employees and, if necessary, advise employees of the hazard.
To Next Page
