Safety
PRM 10 E | Version 1.05 | EN 9
2.6 Safety markings on the motorized ring bending machine
There are various safety markings on the motorized bending machine (Fig. 1),
which must be observed and followed.
Fig. 1: Safety markings - 1 Danger warning | 2 Warning of dangerous electrical voltage | 3 Warning
of crushing of the upper limbs | 4 Earth symbol | 5 Prohibition for contact | 6 Safety regula-
tions, protective equipment
The safety markings attached to the motorized bending machine must not be
removed. Damaged or missing safety markings can lead to malfunctions, per-
sonal injury and property damage. They are to be replaced immediately. If the
safety markings are not immediately recognizable and comprehensible, the
motorized bending machine shall be taken out of service until new safety mar-
kings have been made.
2.7 Safety equipment
2.7.1Installed safety devices
Emergency stop button Press the emergency stop button (fig. 2) located on the control panel and the
machine will stop immediately. The power supply is switched off or the drives
are mechanically disconnected. After the emergency stop button has been
pressed, it must be unlocked by turning so that it can be switched on again.
Fig. 2: Emergency stop button
WARNING!
Danger to life due to non-functioning safety
devices!
Failure to operate or disable the safety equipment can result
in serious injury or even death.
- Before starting work, check that all safety equipment is in
place and correctly installed.
- Never override or bypass safety devices.
- Ensure that all safety devices are always accessible.
WARNING!
Danger to life due to uncontrolled restart!
Uncontrolled restarting of the machine can lead to serious
injuries or even death.
- Before switching on again, make sure that the cause of the
emergency stop has been eliminated and all safety devices
are installed and functional.
- Only unlock the emergency stop button if there is no longer
any danger.
To Next Page
