Spare Parts
PRM 10 E | Version 1.05 | EN 29
10.3Disposal of lubricants
The disposal instructions for the lubricants used are provided by the lubricant
manufacturer. If necessary, ask for the product-specific data sheets.
11 Spare Parts
11.1Spare parts order
The spare parts can be obtained from the dealer or directly from the manu-
facturer. The contact details are in chapter 1.2 Customer Service.
Always quote the following key data with your spare parts orders:
- Device type
- Article number
- Position number
- Year of manufacture
- Quantity
- Desired shipping type (post, freight, sea, air, express)
- Shipping address
Spare parts orders without the aforementioned data can-not be taken into ac-
count. The supplier shall determine the shipping type if no relevant data was pro-
vided.Information about the device type, item number and year of manufacture
can be found on the type plate. The type plate is mounted on the machine.
Example:
The upper shaft for the ring bending machine PRM 10 E has to be ordered.
This is indicated in the spare parts drawing 2 with the item number 24.
By ordering spare parts, send a copy of the spare parts drawing (2) with the
marked part (shaft) and marked positon number (24) to the dealer or spare
parts department and provide the following information:
Type of machine: Ring Bending Machine PRM 10 E
Item number: 378 0011
Drawing number: 2
Position number: 24
DANGER!
Risk of injury due to incorrect spare parts!
The use of incorrect or faulty replacement parts may cause
danger to the operator and cause damage and malfunction.
- Only use original spare parts from the manufacturer or re-
placement parts approved by the manufacturer.
- In case of doubt, always contact the manufacturer.
Tips and recommendations
It must be used bending rollers that are suitable for the
material to be processed.
To Next Page
