14 PRM 10 E | Version 1.05 | EN
Assembly
5.2 Delivery
Standard accessories - included The motorized ring bending machine is delivered with:
- Hardened standard bending rolls
- 2 driven rollers
- mechanically adjustable upper roller
- Shafts made of special steel, hardened
- lateral guide rollers, infinitely adjustable for spiral bending
- the ability to position the motorized bending machine horizontally and
vertically.
- a separate control panel with foot control.
- an operating manual.
Optional accessories - not included Optionally, the following special accessories for the motorized ring bending
machine can be ordered:
- Special guide rollers on the side
- Special bending rolls for pipes and profiles
6 Assembly
6.1 Set up
Requirements for the installation
site
To achieve a good functioning of the motorized bending machine and a long
service life, the site should meet the following criteria.
- The foundation must be level, firm and vibration-free.
- The foundation must not let any lubricant through.
- The installation or working room must be dry and well ventilated.
- Do not operate machines that cause dust and chips near the motorized
ring bending machine.
- There must be sufficient space for the operating personnel, for material
transport as well as for adjustment and maintenance work.
- The site must have good lighting.
WARNING!
Danger to life due to undersized buildings!
Overloading of ceiling structures leads to serious property
damage and bodily injury up to death!
- If the machine is placed on a self-supporting building ceiling,
the dynamic loads due to the movements must be taken into
account - the foundation must support the machine.
NOTE!
Property damage due to uneven ground!
An uneven surface causes deformation within the machine.
This leads to an inaccurate machining of the workpieces.
- Set up the machine on a flat and level surface.
To Next Page
