Cleaning and maintenance
PRM 10 E | Version 1.05 | EN 27
9.1 Cleaning
Clean the rollers of the motorized ring bending machine daily. Attention: do not
use oil or grease! The rollers and material must be clean and grippy to allow
the material to bend without slipping.
Clean all plastic parts with a soft, damp cloth. Never use solvents to clean pla-
stic parts or painted surfaces. A detachment of the surface and the resulting
consequential damage can occur.
Wipe up lubricants with an absorbent, non-fluffing cloth.
Over time, the fan of the electric motor could get dusty. Blow out all ventilation
paths at regular intervals with dry compressed air. Wear protective goggles.
Have the machine thoroughly cleaned and checked at least once a year by an
approved service company.
9.2 Lubrication
Fig. 18: Lubrication points on the ring bending machine
ATTENTION!
The rollers of the machine must not be greased or oiled so
that the rollers can not slip off the bending material during
the bending process. The rollers and the bending material
must always be clean and free of grease!
Always wear suitable safety goggles when
cleaning with compressed air!
Nr. Equipment part Interval lubricant
1 Thread of the spindle Every day Grease
2 Bearings of rollers, waves weekly Grease, Oil
3 Bearings of guide rollers weekly Grease
4 Gears per month Grease
To Next Page
