4 PRM 10 E | Version 1.05 | EN
Introduction
1Introduction
You have made a good choice in purchasing a METALLKRAFT Ring Bending
Machine
Read the operating instructions carefully before commissioning.
This informs about the proper commissioning, the intended use as well as the
safe and efficient operation and maintenance of the motorized ring bending
machine.
The operating instructions are part of the machine. It must always be stored at
the place of use of the motorized ring bending machine. In addition, the local
accident prevention regulations and general safety regulations apply for the
area of application of the motorized ring bending machine.
Illustrations in this operating manual serve the general understanding and may
deviate from the actual design.
1.1 Copyright
The contents of this manual are protected by copyright. Their use is permitted
when using the machine. Any further use is not permitted without the written
permission of the manufacturer.
We hereby apply for trademark, patent and design rights to protect our pro-
ducts, if this is possible in individual cases. We vigorously oppose any infringe-
ment of our intellectual property.
1.2 Costumer Service
Please contact your dealer if you have any questions about your machine or
technical information. There you will be happy to help with expert advice and
information.
Germany:
Stürmer Maschinen GmbH
Dr.-Robert-Pfleger-Str. 26
D-96103 Hallstadt
Repair-Service:
Fax: 0049 (0) 951 96555-111
Email: service@stuermer-maschinen.de
Spare parts orders:
Fax: 0049 (0) 951 96555-119
Email: ersatzteile@stuermer-maschinen.de
We are always interested in information and experiences that arise from the
application an can be valuable for the improvement of our products.
To Next Page
