28 PRM 10 E | Version 1.05 | EN
Disposal, Recycling of old equipment
9.3 Cleaning the electrical box
Step1: Switch off the machine and disconnect the power plug.
Step 2: Open the electrical box and clean it inside with a dry cloth. Never use
liquid detergents!
Step 3: Check the connections to the various connections, secure looser
connections.
Step 4: Close the door of the electric box and connect the machine to the
mains. Start the machine and check all functions.
9.4 Disruptions, possible causes and measures
10 Disposal, Recycling of old equipment
In the interests of the environment, care must be taken to ensure that all com-
ponents of the machine are disposed of in the proper and approved way.
10.1Decommission
Disused machinery and machine components must be taken out of service im-
mediately in order to avoid later misuse and endangering the environment or
people.
- Dispose of all environmentally hazardous fluids from the old device.
- If necessary, disassemble the machine into manageable and usable compo-
nents and components.
- Supply the machine components and operating materials to the appropriate
disposal channels.
10.2Disposal of electrical equipment
Electrical equipment contains a variety of recyclable materials and environ-
mentally harmful components. These components must be separated and pro-
perly disposed of. If in doubt, contact municipal waste management. If neces-
sary, the help of a specialized waste disposal company can be used for the
treatment.
Disorder possible causes Remedy
The motorized ring bending machine
does not work.
1. The electrical connection could be
wrong.
1. Check the electrical connection.
2. Contact the dealer / manufacturer.
The engine is still running, but the
motorized ring bending machine is
not moving.
1. The engine is turning in the wrong
direction.
1. Check the motor rotation direction.
2. Contact the dealer / manufacturer.
The motorized ring bending machine
does not bend the materials as sta-
ted in the catalog.
1. The material thickness could be
wrong.
1. Check the material to be bent.
2. Contact the dealer / manufacturer.
To Next Page
