MI 3000 EasiPLUS Instrument operation
18
4.1.2 Message field – battery status
Battery power indication.
Low battery indication. Battery pack is too weak to
guarantee correct result. Replace the batteries.
Recharging is running (if power supply adapter is
connected).
4.1.3 Message field – measurement warnings/messages
Warning! High voltage is applied to the test terminals.
Warning! Phase voltage on the PE terminal! Stop all the
measurements immediately and eliminate the fault before
proceeding with any activity!
Measurement is running. Consider any displayed
warnings!
Measurement can be performed after pressing the TEST
key. Consider any displayed warning after starting the
measurement!
Measurement prohibited. Consider any displayed
warnings and check online voltage/terminal monitor!
Co
Test leads resistance in low-value resistance
measurement is compensated.
RCD tripped during the measurement. The trip limit may
be exceeded as a result of leakage current flowing to the
PE protective conductor or capacitive connection
between L and PE conductors.
RCD not tripped during the measurement.
Instrument overheated. Temperature of internal
components in the instrument reached top limit.
Measurement is prohibited until the temperature is lower
then that limit.
Battery capacity is too low to guarantee correct result.
Replace the batteries.
To Next Page
Loading...
Need help?
General
