Functional Description
44 50,000-count Benchtop Multimeter
Functional Description (continued)
SURV (cont.) The current "MIN" and "MAX" display is shown in the same range.
When accessing "SURV" mode, after briefly pressing key, "MIN" and
"MAX" measurements are initialised with the current measurement.
Each time "MIN" or "MAX" are detected, a beep is triggered (if the "bEEP
OFF" configuration was not selected in MENU).
After monitoring is finished, keep the "SURV" key pressed down to consult
the recorded and timed "MIN" and "MAX".
First the start of monitoring date and time are displayed, then press
"SURV" briefly to consult the time stamped "MIN" and "MAX".
Keep pressed down to exit reading.
STORE "STORE" mode is not available on the basic version. Users require the
ACQUISITION option.
"STORE" mode allows you to record a measurement in the unit memory at
a preprogrammed rate.
When you trigger this mode, the instrument temporarily displays the first
free memory number (Mem 0 to Mem 9) and assigns it. The "STORE"
symbol flashes during the whole recording period. A beep is emitted each
time a measurement is acquired.
You can access and exit this mode by pressing "STORE".
"STORE" mode
management
MEM 0
CLEAr On, CLEAr OFF
rAtE
dEPth
"STORE" mode is configured in a programming mode: the "PROG STORE"
mode.
You can access four programming mode phases by successively pressing
"STORE":
• reading already recorded data (Mem 0 to Mem 9 or Mem empty)
• clearing memory
• programming mode rate (rAtE + value)
• programming recording depth (dEPth + value)
Reading already
recorded data
The main display shows the number of the first memory containing data,
while displays 2 and 3 show the date and time that this recording started.
Rotary button LEDs flash and a button key allows you to select the memory
to be shown, if there are several recordings. It is selected via the "VALID"
key.
Then the instrument shows the recording number "dooo to dxxx", date and
time.
Use the:
• wheel to see the number of recordings made
• "VALID" key to display stored measurement(s).
You can scroll them via the rotary button and display their recording
number, date and time at any time.
Clearing memory
The main display shows "CLEAR" and wheel LEDs flash. Use the wheel to
show "ON" or "OFF" on display 2, that you can confirm via "VALID" key.
To Next Page
Loading...
Need help?
General
