Metrix MTX 3292 - Page 17

Functional description
100,000 cts digital multimeters 17
Description of the “SETUP” menu (continued)
Level 2
Sub-level 1/3
(continued)
Display (2/2)
 Language: selection of the language used in
the menus of the multimeter. Two options are
possible: French (FR, the default) or English.
 Clock: selection of:
- the date, format (01/01/2014 is default)
- the time XX:XX:XX, or h:min:sec
- selection of variables with the navigator
- Resolution 1s
Communication
 Type IR/BT: choice of communication:
- IR/USB
- Bluetooth
 IR Baud: parameterizing of the infrared
transmission rate from among
9600/19200/38400 (default) baud;
the other transmission parameters are fixed
(8 data bits, 1 stop bit, no parity)
 Protocol: choice of MODBUS or SCPI
Power supply
 Type: choice of type:
- Ni-MH battery
- Alkaline primary battery
 Capacity: parameterizing of the capacity of
the storage battery in mAh, of the batteries
installed (default is 2400mAh).
1. Place the storage batteries in the multimeter,
then connect the charger.
The LEDs light alternately around the switch to
indicate that charging is in progress.
2. Press ON to switch the multimeter on and track the course of the charging by plateau.
Average charging time: 6h (with 2400mAh storage batteries).
After 1h of recharging, the multimeter is ready for measurements, by pressing ON again;
the level of the plateaus acquired is valid only after a full charge of the instrument.
www.ShopAEMC.ca
Shop for AEMC products online at:
1.800.561.8187