Microchip Technology MPLAB ICD 5 - Page 18

Connecons
User Guide
© 2023 Microchip Technology Inc. and its subsidiaries
DS-50003529B - 18
3.3.3 Debugger Adapter Board
The Debugger Adapter Board is a connectivity board that gives MPLAB ICD 5 and MPLAB PICkit
5 Debuggers cable compatibility to demo boards with Atmel-ICE, Power Debugger and ARM style
connectors. It supports JTAG, SWD and ICSP protocols in multiple connector formats. It is useful for
debugging AVR Xplained demonstration boards with MPLAB PICkit 5 debuggers.
Table 3-4. Connecon to Device Mappings
Connector Device Input/Output
J1 RJ-11 modular connector for ISCP (PIC
MCUs)
Input from tool
J2 JTAG/SWD, 20 pin - SAM MCUs Output to target
J3 JTAG (MIPS EJTAG), 14 pin - PIC32 MCUs Output to target
J4 JTAG/SWD, 10 pin mini - SAM MCUs Output to target
J5 ICSP/JTAG, 8 pin mini - PIC MCUs Output to target
J6 8-pin single inline connector for ICSP
(PIC MCUs)
Input from tool
J7 AVR JTAG, 10 pin mini - AVR MCUs Output to target
3.3.3.1 Adapter Board Pinout
This is a connectivity board that supports JTAG, SWD, ICSP and AVR protocols.