Microchip Technology MPLAB ICD 5 User Manual

Error Messages
User Guide
© 2023 Microchip Technology Inc. and its subsidiaries
DS-50003529B - 73
2. Make sure the debugger is physically connected to the computer on the appropriate USB port.
3. Make sure the appropriate USB port has been selected in the debugger options (see section
Debugger Options Selection).
4. Make sure the USB port is not in use by another device.
5. If using a USB hub, make sure it is powered.
6. Make sure the USB drivers are loaded.
8.2.6 Debug Failure Acons
The MPLAB ICD 5 In-Circuit Debugger was unable to perform a debugging operation. There are
numerous reasons why this might occur. See section Troubleshooting.
8.2.7 Internal Error Acons
Internal errors are not expected nor should happen. They are used for internal Microchip
development.
The most likely cause is a corrupted installation ( Corrupted Installation Actions).
Another likely cause is exhausted system resources:
1. Try rebooting your system to free up memory.
2. Make sure you have a reasonable amount of free space on your hard drive (and that it is not
overly fragmented).
If the problem persists, contact Microchip Support.

Microchip Technology MPLAB ICD 5 Specifications

General

Brand	Microchip Technology
Model	MPLAB ICD 5
Category	Microcontrollers
Language	English