Microhard Systems IPN4G - Page 157

© Microhard Systems Inc. 157
5.0 AT Command Line Interface
AT+MPWD
Command Syntax
Used to set or change the ADMIN password for the
IPn4G.
AT+MPWD=<New password>,<confirm
password>
password: at least 5 characters
Description
Example
Input:
AT+MPWD=admin,admin<enter>
Response:
OK
AT+MDISS
Command Syntax
Configure discovery mode service used by IPn4G
and utilities such as “IP Discovery”.
AT+MDISS=<Mode>
Mode:
0 Disable
1 Discoverable
Description
Example
Input:
AT+MDISS=1 <enter>
Response:
OK
AT+MIKACE
Command Syntax
Enable or Disable IMCP ICMP keep-alive check.
AT+MIKACE=<Mode>
Mode:
0 Disable
1 Enable
Description
Example
Input:
AT+MIKACE=1<enter>
Response:
OK