Microhard Systems IPN4G - SMTP Client

© Microhard Systems Inc. 89
4.0 Configuration
IP Protocol Config (Continued…)
SMTP Client: If the IPn4G has Internet access, this protocol may be used to send the data
received on the serial port (COM1), in a selectable format (see Transfer Mode (below)), to an e-
mail addressee. Both the SMTP Server and the e-mail addressee must be ‘reachable’ for his
feature to function.
 Mail Subject
Enter a suitable ‘e-mail subject’ (e-mail heading).
Default: COM1 Message
 Mail Server (IP/Name)
IP address or ‘Name’ of SMTP (Mail) Server.
Default: 0.0.0.0
 Mail Recipient
A valid e-mail address for the intended addressee, entered in the proper format.
Default: host@
 Message Max Size
Maximum size for the e-mail message.
Default: 1024
 Timeout (s)
How long the unit will wait to gather data from the serial port before sending an
e-mail message; data will be sent immediately upon reaching Message Max
Size.
Default: 10
 Transfer Mode
Select how the data received on COM1 is to be sent to the email addressee.
Options are: Text, Attached File, Hex Code.
Default: Text
SMTP: Simple Mail
Transport Protocol is a
protocol used to transfer
mail across an IP
network.