Microhard Systems IPN4G - Page 159

© Microhard Systems Inc. 159
5.0 AT Command Line Interface
AT+MEURD1
AT+MEURD2
AT+MEURD3
Command Syntax
Define Event Report UDP Report No.1/2/3.
AT+MEURD1=<Mode>[,<Remote IP>,<Remote
Port>,<Interval Ti
me_s>]
Mode:
0 Disable
1 Moden Event Report
2 SDP Event Report
3 Management Report
Description
Example
Input:
AT+MIKAC=www.google.com,600,10<enter>
Response:
OK
AT+MNMSR
Command Syntax
Define NMS Report.
AT+MNMSR=<Mode>[,<Remote Port>,<Interval
Time_s>]
Mode:
0 Disable
1 Enable NMS Report
Description
Example
Input:
AT+MNMSR=1,20200,300<enter>
Response:
OK
AT+MGPSR1
AT+MGPSR2
AT+MGPSR3
AT+MGPSR4
Command Syntax
Define GPS Report No.1/2/3/4.
AT+MGPSR1=<Mode>[,<Remote IP>,<Remote
Port>,<Interval Ti
me_s>]
Mode:
0 Disable
1 Enable UDP Report
Description
Example
Input:
AT+MGPSR1=1,192.168.168.25,20175,600 <enter>
Response:
OK