Revision History
UG0451 User Guide Revision 7.0 1
1 Revision History
The revision history describes the changes that were implemented in the document. The changes are
listed by revision, starting with the most current publication.
1.1 Revision 7.0
The following is a summary of the changes in revision 7.0 of this document.
• The programming method for auto programming SPI Directory was updated inTable 1, page 3.
• Throughout the document the term user security was changed to custom security.
• A reference was added for digest based verification in Programming Bitstream Generation, page 8.
• A precautionary note was added in Design Implementation, page 15.
• Additional references were added in Programming Recovery Implementation, page 37.
1.2 Revision 6.0
The following is a summary of the changes in revision 6.0 of this document.
• Information about IAP flow was updated. For more information, see Figure 17, page 34.
• Information about MSS ISP update flow was updated. For more information, see Figure 14, page 27.
• Information about IAP error codes was updated. For more information, see Figure 19, page 33.
• Information about programming recovery and auto update was updated. For more information, see
Figure 25, page 40.
1.3 Revision 5.0
The following is a summary of the changes in revision 5.0 of this document.
• Information about programming overview was updated. For more information, see Table 1, page 3
and Ta ble 2, page 6.
• Information about programming flow was updated. For more information, see Programming Flow,
page 11.
• Information about design implementation for JTAG programming was updated. For more
information, see Design Implementation, page 15.
• Information about programming interface for SPI slave programming was updated. For more
information, Programming Interface Overview, page 13.
• Information about design implementation for auto programming was updated. For more information,
see Design Implementation, page 21.
• Information about auto programming of M2S/M2GL050 devices was added. For more information,
see Auto Programming of M2S/M2GL050 Device, page 23.
• Information about design implementation for MSS IP was updated. For more information, see
Design Implementation, page 24.
• Information about auto update was updated. For more information, see Auto Update, page 35.
• Information about configuring the MSS/HPMS SPI_0 port was updated. For more information, see
MSS/HPMS SPI_0 Port Configuration, page 39.
• Information about production programming was updated. For more information, see Production
Programming, page 41.
• Information about I/O sates was updated. For more information, see State of SmartFusion2 and
IGLOO2 Components During Programming, page 42.
• Changed the document to the new template.
1.4 Revision 4.0
Updated introduction of Auto Programming chapter (SAR 67871).
1.5 Revision 3.0
The following is a summary of the changes in revision 3.0 of this document.
To Next Page
Loading...
