Before After
To use this feature:
Choose the Invert command in the Preferences menu. A check (V)
appears next to the command when it is enabled.
Retain Scan Module After Scan (unimplemented)
This command allows you to keep the ScanWizard 5 interface after
scanning is completed and after the image is delivered to your
image-editing software. This way, you do not have to go back to the
File-Acquire process to start ScanWizard 5 all over again.
Note: This command can be used only in applications (such as
Adobe Photoshop) that allow you to retain the scan module after a
scan is completed. Some applications may not retain the scan
module even if this option is enabled.
To use this feature:
Choose the command Retain Scan Module after Scan in the
Preferences menu. A check (v) appears next to the command when
it is enabled. If you wish to see the scanned image in your image-
editing software after scanning is completed, you will need to quit
ScanWizard 5 to see the image.
More... command
The More... command lets you specify other rarely used
To Next Page
Loading...
Need help?
General