Example: If you changed the tone curve, applied filters, changed
brightness, then clicked Revert, the brightness changes will be
cancelled, but the altered tone curve and filters settings remain in
effect.
OK button
Clicking on this button will apply whatever Image Corrections you
have performed on the current scan job, and close the AIC dialog
box.
Example: If you increased brightness, changed the saturation, and
then clicked OK, all the changes are applied, and you exit the AIC
dialog box. In the Settings window, the "W&B Points" menu will
display "Custom".
Cancel button
Clicking on this button will cancel out all image correction changes
you have made to the current scan job, and then close the AIC
dialog box. The settings remained unchanged.
Example: If you applied filters, changed the curve, and then clicked
Cancel, none of the changes will take effect, and you exit the AIC
dialog box.
Default button (in the Settings window)
The Default button in the Settings window brings up a dialog box
where you can specify the AIC settings to be reset to their default
values. To reset any or a combination of settings, check the boxes
next to the targeted settings.
To Next Page
Loading...
Need help?
General