Do I have access to the Microtek Scanner
Configuration (MSC) Utility?
The Microtek Scanner Configuration (MSC) utility is a companion program
of ScanWizard 5. This utility works only if your scanner model is equipped
with Smart-Touch buttons located on the front panel of the scanner. If
your Microtek scanner is equipped with Smart-Touch buttons, you can use
the buttons to complete common scanning tasks.
How to configure the Smart-Touch buttons with MSC utility
1. Launch the MSC Utility by double-clicking the Microtek Scanner
Configuration icon from the desktop.
2. When the MSC panel appears, click on a tab to redefine the settings
you want.
Note:
ScanWizard 5 and MSC are programs that run exclusively. This means that
ScanWizard 5 and MSC should be used one at a time and not
simultaneously.
How ScanWizard 5 works with the scanner buttons
When ScanWizard 5 is launched from the desktop, the Scan, Copy, or E-
mail buttons will complete an overview and set the "Scan To" button in
ScanWizard 5 to reflect the scan function you chose.
When ScanWizard 5 is launched from an image-editing application, the
Scan, Copy, or E-mail buttons will perform only a prescan.
Relationship between MSC and the scanner buttons
The MSC utility is available for you to set parameter settings for the
respective scanner button. When MSC is launched, press the button to
carry out its corresponding function.
To Next Page
Loading...
Need help?
General