Microtest 6375 - Page 60

6–22
MEASUREMENT MODE
:MEAS:SCALE <disc>
Show / Hide the scale bar.
Parameters:
The following parameters are valid:
ON Show scale.
OFF Hide scale.
Example: :MEAS:SCALE OFF
will turn off the scale.
Response:
None.
:MEAS:SCALE?
Returns the current status of the scale bar.
Parameters:
None.
Response:
Returns scale setting according to this
table:
0 Scale hidden.
1 Scale visible.
Example: 0
indicates that the scale is currently
hidden.
:MEAS:NOMinal <real>
Set nominal value for scale.
Parameters:
The required nominal value. If a unit is
supplied it must that of either the first
or second measurement otherwise the
unit mismatch error will be set. If no
unit is supplied the current nominal
unit will be used.
Examples:
:MEAS:NOMINAL 1e-6F
will set a nominal of 1µF.
:MEAS:NOMINAL 0.47e-5
will set a nominal of 4.7µF
Response:
None.
:MEAS:NOMinal?
Returns the scale bar graph nominal value.
Parameters:
None.
Response:
Returns the nominal in engineering
format.
Example: +.10000000E-01
would indicate a nominal of 10mH if
the first nominal unit is Henrys.