Miele PG 8056 U - Connecting the Drain Hose

Plumbing
*INSTALLATION*
118
Connecting the drain hose
- The dishwasher drainage system is fitted with a non-return valve,
which prevents dirty water from flowing back into the dishwasher
via the drain hose.
- The dishwasher should preferably be connected to a separate on-
site drainage system. If no separate connection is available, we
recommend connection to a double chamber siphon. The on-site
connection must be between 0.3m and 1m height, measured from
the lower edge of the dishwasher. If the connection is lower than
0.3m the drain hose must be placed in an arc at least 0.3m high.
- The dishwasher is equipped with a 1.5m flexible drain hose with an
internal diameter of 22mm. Hose clips are supplied with the
dishwasher.
- The drain hose must not be shortened. The hose can be extended
using a connection piece to attach a further length of hose. The
drainage length must not be longer than 4m.
- The drainage system must be able to accommodate a minimum
drainage flow of 16 l/min.
 Make sure that there are no kinks in the hose, and that it is not
squashed or stretched.
See installation diagram supplied.