Miele PG 8056 U - Problem Solving Guide; Faults with Water Inlet or Drainage

Problem solving guide
97
With the aid of the following guide, most minor problems can be corrected without
contacting Miele. You can save time and money in many cases, as you do not need to call
the Miele Customer Service Department.
The following guide should help you to find the reason for a malfunction or fault, and to
correct it. You should, however, note the following:
 Repairs must only be carried out by the Miele Customer Service Department, an
authorised Miele dealer or a suitably qualified technician in accordance with local and
national safety regulations. Unauthorised or incorrect repairs can cause considerable
danger to users.
Faults with water inlet or drainage
Problem Cause and remedy
When the dishwasher is
switched on with the
button, the display stays
dark and the Start/Stop in-
dicator does not flash.
The dishwasher is not plugged in.
 Insert the plug and switch on at the socket.
The fuse has tripped.
 Reset the trip switch
(minimum fuse rating - see data plate).
The dishwasher stops dur-
ing a programme.
The fuse has tripped.
 Reset the trip switch (minimum fuse rating - see data
plate).
 If the mains fuse trips again, call the Miele Service
Department.
Interruption to the power
supply during operation
If a temporary interruption to the power supply occurs
during a programme sequence, no action is required.
The programme will continue after the interruption.
If the temperature in the wash cabinet drops below the
minimum value required for the programme block during
the interruption to the power supply, the programme
block will be repeated.
If there has been an interruption to the power supply of
≥20hours, the entire programme will be repeated.
One of the following faults
appears in the display:
Before rectifying the problem:
 Switch the dishwasher off with the button.
Check water inlet Water inlet fault.
 Open the stopcock fully.
 Clean the filter in the water inlet (see “Cleaning and
care”).