Technical Information
32
PW 6xx7
No. Program step Basic
setting
Setting options Notes
11 Dispensing
type: (depends
on the setting
for Fill type in
the program
header for this
program)
No No No liquid dispensing.
Qty. in mL Quantity of dispensed agent in mL.
Concentration mL/kg Quantity of dispensed agent in mL/kg
laundry.
Concentration mL/L Appears when Fill type is programmed to
Laundry:Suds ratio in kg/L or Water
quantity in L in the program header.
Does not appear if Fill type is
programmed to Auto load adjustment or
Water height in mm. Quantity of
dispensed agent in mL/L water.
12 Dispensing
phase 1
No or lock
symbol, if
Dispensing
type has
been pro-
grammed to
No
Lock symbol Selection blocked because no dispensing
type has been programmed.
No No dispensing phase 1.
User-defined From a list of up to 13 dispenser pumps
(depending on model), up to 6 dispenser
pumps can be programmed for each
dispensing phase. The programmer can
e.g., select the following with this
dispensing phase 1: “Dispensing: 1”,
“Dispenser pump 1”, “Dispensed quantity:
50 mL”, “Dispenser time delay: 30 s”.
13 Dispensing
stop 1
No or lock
symbol, if
no
dispensing
type pro-
grammed
Lock symbol Locked if no dispensing type selected.
No Dispensing takes place at the same time
as program steps Intake path 1,
Agitation from level and Wash time 1. If
the duration of a dispensing cycle is
longer than Wash time 1, then it is
stopped when Wash time 1 finishes.
Yes The program step Wash time 1 starts
after dispensing has finished.
14 Agitation from
level
Automatic Automatic Drum agitation begins with the water
intake. The speed and rhythm are taken
from the Wash time 1 program step.
User-defined The programmer sets the drum agitation
for the first water intake in a program
block. From a selected level, drum
agitation with a set rhythm and speed
occurs for a set time. Example: “Time: 1
min 30 s”, “Rhythm: Gentle”, “Speed:
Normal”, “Agitation start: 30 mm”. This
means that from a level of 30 mm wc the
drum will rotate with a rhythm of “3 s
rotation / 27 s pause” with 45 rpm (PW
6137 as example) for 1 min 30 s. The
program step Wash time 1 starts after
the time set with program step Agitation
from level has elapsed.
15 Level stop 1
No No Water inlet takes place at the same time
as program steps Dispensing phase 1,
Agitation from level and Wash time 1.
Yes Water is first taken in until the
programmed water level is reached. The
control interrupts further program
operation until this has occurred and then
starts drum agitation with the settings
made for program step Agitation from
level. The Wash time 1 step starts after
the programmed level 1 has been
reached or after the time set with
program step Agitation from level has
elapsed.
To Next Page
Loading...
Need help?
General
