Technical Information
35
PW 6xx7
No. Program step Basic
setting
Setting options Notes
24 Cooldown
No No No controlled suds cooling takes place.
Automatic Controlled suds cooling takes place at rate
of 3°C/min. The valve programmed for the
Intake path 2 program step is opened
intermittently to take in water until the
maximum level in the machine is reached.
Drainage then takes place down to the
wash level via the valves programmed in
the Drainage path 1 program step. Water
intake and drainage are then repeated
alternately until the suds temperature has
dropped to 45°C.
User-defined Controlled suds cooling takes place. The
valve programmed for the Intake path 2
program step is opened intermittently to
take in water until the maximum level in
the machine is reached. Drainage then
takes place down to the wash level via the
valves programmed in the Drainage path
1 program step. Water intake and
drainage are then repeated alternately
until the selected suds temperature has
been reached. The suds temperature can
be set between 20°C and 95°C in 1°C-
steps. The cooling speed can be set
between 1°C/min and 20°C/min in 1°C-
steps.
25 Wash time 3
No No No Wash time 3 carried out (no Wash time
after cooldown).
User-defined The programmer sets the drum agitation
for washing for a set duration with set
rhythm and speed. Time selectable
between 0 min 0 s and 99 min 59 s in 1-s
steps. Rhythm options “No”, “Normal”,
“Gentle+”, “Gentle” and “User-defined”.
With “User-defined”, the on time must be
between “2 s" to “99 s" and the off time
between “2 s” and “99 s” with the sum >
15 s. Speed options “No”, “Normal”,
“Drench” and “User-defined”. “User-
defined” selectable between 20 rpm and
70 rpm in 1-rpm steps.
26 Program stop 2
No No No stop during program.
Permanent Program always stops at this point.
Program is continued by pressing the
Start button.
Starch stop Program stops at this point if the operator
has pressed the Starch stop button
before the program reaches this stage in
the program sequence. Program is
continued by pressing the Start button.
Spin stop Program stops at this point if the operator
has pressed the Spin stop button before
the program reaches this stage in the
program sequence. Program is continued
by pressing the Start button.
Spin stop and starch
stop
Program stops at this point if the operator
has pressed the Starch stop and Spin
stop buttons before the program reaches
this stage in the program sequence.
Program is continued by pressing the
Start button.
To Next Page
Loading...
Need help?
General
