How to Change the System from Standby to Ready
Keeping the system processes in Ready means the system automatically changes
software modes to produce water when required.
Procedure
Important: Standby should only be used to stop the corresponding process in the
event of a leak or maintenance purpose.
If a process is not in a READY mode the operating mode will display STANDBY.
1. The Makeup and Distribution processes can be changed between STANDBY and
READY using the three horizontal bars at the top of their respective window.
(I): Makeup; (II): Distribution
Note: When the system is not managing a distribution loop, the distribution panel
is not active and in this case does not display the three horizontal bars.
2.
Press on the icon on the horizontal bar of the process that you wish to change.
By clicking on the bar => Process mode switches:
System Display | 23
To Next Page
Loading...
Need help?
General
