PROGRAM MODE ENTRY
Upon initial power application, the XPL+ displays "OFF". To enter the program mode...
1. Ensure the enclosure lid is secured by the 6 captivated screws.
2. Place the infrared programmer in the enclosure lid recess (no wiring or fastening required).
3.
When the program mode is entered after RUN mode operation, all operating data is retained in memory.
Relay status and mA output values are held at "last known" values (unless affected by a parameter alteration
or is pressed) until the RUN mode is re-entered. The RUN mode is automatically re-entered if the
XPL+ is left unattended in the program mode for an extended period.
PARAMETER VALUE ALTERATION
In the program mode...
1. as required to underline the Parameter Number display field and...
a) key in the desired Parameter Number, (
direct access
) or...
b) or as required (
scroll access
).
(As preset, Quick Start Parameters and any previously altered parameter may be scroll accessed.
2. as required to underline the Point Number display field and...
a) key in the desired Point Number, (
direct access
) or...
b) or as required, (
scroll access
).
To alter the Parameter Value for all Point Numbers at once, direct access Point Number 00.
3. With the desired Parameter Number and Point Number displayed...
key in the desired Parameter Value and,
If Parameter Value alteration is not permitted, access the Lock parameter (P000)
and enter the security code (See Programming Security).
%
PROGRAMMING
PL-532 21
To Next Page
Loading...
