MIMAKI ML Tiger-1800B MKII - Printing Workflow; Job Import and Printing Steps

11
Flow to printing
Print a job created with the RIP application by the following procedure.
Please check the following before printing.
· Perform a test print and check the nozzle status. Perform cleaning as necessary.
· Make sure that the pressure roller is descending and pressing the media.
· Check the ink level and media level.
· Check whether an alarm has occurred.
If an alarm has occurred, remove the cause of the alarm and clear the alarm.
1. Import of a job
See [Import of jobs (P.12)]
2. Selection of the job to print
3. Setting of print conditions
4. Start printing
5. Print end and print operation