MIMAKI ML Tiger-1800B MKII - Machine Tab Functions; Machine Component and Operation Settings

83
[Machine] tab screen
No. QPrint menu Function MPC menu
1 Photocell Folds photocell
Turns On/Off the Obstacle
sensor.
[SETTING] - [Machine] -
[Obstacle sensor]
2
Auto
Cleaning
In Printing
Sets Auto Cleaning during
printing.
[MAINTENANCE] - [Auto
maintenance] - [Cleaning (Print)]
3 Offline
Sets Auto Cleaning during
waiting.
[MAINTENANCE] - [Auto
maintenance] - [Cleaning (Idle)]
4
Pressing
cylinder
Man / Auto
Turns On/Off the Pressure
roller.
[SETTING] - [Pressure roller] -
[Auto setting]
5
Reset
machine
Start Initiates machine reset.
[SYSTEM] - [Power] - * Various
reset menus
6
Reset all
machine cycle
Resets all PLC cycles.
7 Reset alarm
Resets an alarm caused
by PLC.
8
Belt washing
Man / Auto
Switching between manual
and auto belt cleaning
[SETTING] - [Washing unit] -
[Auto setting]
9
Manual up /
down tank
Raise and lower the
washing tank manually.
[SETTING] - [Washing unit] -
[Washing tank]
10
Manual enabling
brush
Manually rotate the
washing brush.
[SETTING] - [Washing unit] -
[Washing brush]
11
Washing
hopper
Pause time
Set the time when the
water supply valve is
closed.
[SETTING] - [Washing unit] -
[Wash water supply]
12 Charging time
Set the time that the water
supply valve is open.
13 Water charge
Set the water supply
operation On/Off.
14
Belt jog
Forward Jog
Turn On/Off the Forward
Jog
[QUICK MENU] - [Forward jog]
[MAINTENANCE] - [Jog
operation] - [Forward jog]
15 Reverse Jog
Turns On/Off the Reverse
Jog
[MAINTENANCE] - [Jog
operation] - [Reverse jog]
16 Jog speed Set the jog speed.
[MAINTENANCE] - [Jog
operation] - [Jog speed]
17
Belt heater
Stop time
Set the belt heater stop
time.
[SETTING] - [Machine] - [Heater] 18 Heating
Set the output of the belt
heater.
19 Heater
Turns On/Off the belt
heater.
20
Air recycle
fans
Fans stop time
Set the carriage ceiling
FAN operation stop time
[SETTING] - [Machine] - [Vent
fan]
21 ON / OFF Fans
Turn On/Of the Carriage
ceiling fan.