18
No. Setting item Description of settings and range of input values
1 Print origin
Specify the print origin based on the media origin.
Input range: 0mm to MAX1600mm * MAX varies depending on
image width
Enter the value of the left position to start printing from the
2 Repeat
Specify the number of times to print the selected job repeatedly.
MAX: Print length x repeat setting = 10000.00 m or less
*1
3 Print length
Specify how many meters the selected job will be printed.
Input range: Image height ~ 9999.00 m
*1
4 Pass
1-4 (pass)
The number of pass available depends on the job's resolution.
Ex.) When the value is 1200 dpi, it can be used with two or
5 Layer
Specify the layer (number of layers).
1 to 4 (layer)
6 Print direction
Direction of scanning to be printed is specified.
Uni-direction / bi-direction
7 Scan speed
High speed (fast) / standard (standard speed)
∗ High speed cannot be selected for big dot job data.
∗ If you set the high speed job to the standard setting, the print
8 MAPS
*2
1) Setting: Auto (Recommended)
Manual (Apply the following input value)
2) Speed: 50% to 100%
The closer to 50%, the lower the print speed. Determine the
value according to the job and image quality.
3) Smoothing: 0% to 100%
Reduce the density differences in the overlapping prints.
The closer to 0%, the thicker the density.
∗ It is necessary to adjust to the optimal density depending on the
9 Setting information display
The following information set in the setting menu is displayed.
Check the contents before printing.
· Media origin
· Color bar
∗ To change the setting, use the setting menu.
*
1
Each repeat and print length varies depending on the set value and image size.
*
2
MAPS: MAPS function (Mimaki Advanced Pass System) is a function that disperses the boundary of the pass
and makes the feed stripe inconspicuous. Depending on the printing conditions, such as 1 pass printing, the
MAPS mask may be visible.
To Next Page
Loading...
