MIMAKI SWJ-320 S2 - Page 5

© 2013 MIMAKI ENGINEERING CO.,LTD.
Table of Contents R.1.1 P.2
MAINTENANCE MANUAL > Table of Contents
Model SWJ-320S Issued 2012.07.19 Revised 2013.08.28 F/W ver. Remark
Table of Contents
1.3
Rev.
6.1.1 Cover Layout
6.2 Ink-related Parts
6.2.1 Ink-tank
6.2.2 Head Unit
6.2.3 Liquid supply pump
6.2.4 Suction pump
6.3 Drive System
6.3.1 X-axis Motor assy.
6.3.2 Y-axis Motor
6.3.3 Linear Encoder Scale
6.3.4 Cleaning of Linear Encoder Scale
6.4 Electrical Parts
6.4.1 Main PCB assy.
6.4.2 Power Supply PBA600F-36-G
6.4.3 Power Supply PLA600F-36-R
6.4.4 180LPI Encorder Sensor
6.4.5 DC power supply assy (5V)
6.4.6 Central-IO PCB assy.
6.4.7 HDC PCB assy.
6.4.8 DDR2PRAM(1GB) assy.
6.4.9 Optical conversion PCB assy.
6.4.10 FPC Changes PCB assy.
6.4.11 Key Board PCB assy.
6.4.12 ID Contact PCB CN032 Simple assy.
6.4.13 Suction FAN
6.4.14 Suction Fan Controller assy.
6.4.15 Suction Fan Relay
6.5 Sensors
6.5.1 Y-origin Sensor
6.6 Pressurizing relations
6.6.1 Air Tank Sensor assy.
6.6.2 Plural solenoid valve assy.
6.6.3 Pressure pump assy.
6.6.4 Pressure switch assy.
6.6.5 Lighting LED assy.
6.7 Repeated winding relations
6.7.1 Feeding Slack Sensor assy.
6.7.2 Take-up Slack Sensor assy.
6.7.3 Feeding Motor assy.
6.7.4 Take-up Motor assy.
6.7.5 Feeding Motor Relay
6.7.6 Take-up Motor Relay
6.8 Heater relations
6.8.1 Temperature controller
6.8.2 SSR
6.9 Drying unit relations
6.9.1 Warm Breeze Fan assy.
6.9.2 Drying Fan assy.
7.Troubleshooting
7.1 Details on Errors and Malfunctions
7.1.1 Concerning Errors and Malfunctions
7.1.2 List of Error Messages
7.1.3 List of Warning Messages
7.1.4 List of SYSTEM HALT
7.2 Detailed Methods of Coping with the
Malfunctions
7.2.1 Sorting process sheet of ink supply
system’s troubles
7.2.2 Checking of the cap leak
8.Operation Flow
8.1 Basic Operation
8.1.1 Start Up
8.2 Print Mode
8.2.1 LOCAL / REMOTE
8.2.2 SETUP
8.2.3 MAINTENANCE
8.2.4 MEDIA SET~INFORMATION
8.3 Service Mode
8.3.1 #ADJUST
8.3.2 #TEST